ClipIt Prybars are here!  <------------And..the're gone!   But worry not more are on the way!

These measure 4.5" X 1/2" X 1/4" are made from A2 tool steel and tempered to about 57 HRC for toughness with a tumbled from heat treat finish which gives a cool random variation in color. Featuring a heat treated stainless pocket clip and a through hole for a lanyard. Get them while they last.

And if you are wondering how tough they are:

 I figured I would test one out so I proceeded to pound the crap out of it with a 2lb sledge. First I drove it through a 2 x 4 along the grain and split a few big chunks off, easy. So I decided to drive it cross grain. A little more pounding but it just laughed at me and went right on in. Ok fine. Then I found some old concrete cinder block around the house and made baby concrete chunks with my prybar as I pounded it right on through bit by bit. Very not bad! The tip ended up with a few scratches and MINOR dings. Then I figured what the hell and drove it into a post and put all of my 215lb ass up on it. My entire mass held up by this little 1/2" wide 1/4" thick piece of metal, it was impressive, I was happy. Unfortunately I was not able to get a pic of me standing on it, kinda hard to do by myself.
   So rest assured These will get the job done for you and then some. This is a limited run, all hand ground and machined by me so there are some slight variations. But that's what makes them hand made and awesome right?
 
While they last these are $old shipped to conUS and add $10 for international shipping please. Email me zwood45@gmail.com or PM me on facebook for purchase. www.facebook.com/zachwoodknives

Thanks for supporting Zach Wood Knives!